Replacement Of Fuse; Vehicle Washing - Serpento SPIRIT 250 Manual De Usuario

• SPIRIT 250
MANUAL DEL USUARIO

Replacement of Fuse

Set the ignition switch to "OFF" position. The specified fuse tube of 10A should be used for replacement.
Open the left side cover, remove the fuse holder on the side of the battery and replace the fuse tube.
If the new fuse tube is broken again as soon as it is fitted on, it means that there is some trouble with other electric parts.
Caution:
Do not use any fuse over15A
Be sure not to wash the battery when washing the vehicle.

Vehicle washing

Cleaning the vehicle regularly can slow down the color fading of its body make it easier to check if there is any damage and any oil leakage
with it.
Caution:
Washing the motorcycle with over-pressurized water may cause damage to some of its components. Therefore, do not jet over-pressurized
water directly on to the following parts:
--Wheel hub
--Exhaust pipe
--Fuel tank and lower portion of cushion
--Carburetor
--Head lock and ignition switch
--Meters
(1) After pre-wiping, the vehicle should be washed with clean water to remove dirty residues so as to prevent corrosion. Plastic subassemblies
should be cleaned by wiping with cloth or sponge soaked in neutral detergent solution, followed by washing with clean water.
(2) After the cleaned vehicle is air dried, grease the chain and run the engine at idling speed for a few minutes.
(3) Prior to driving, carefully check braking system repeatedly and repair of adjust it if necessary.
29