Pump Set Dislodged Error; Battery Low; Feeding Complete; Pump Set Use >24 Hours Warning - Coviden Kangaroo ePump Manual De Instrucciones

Bomba para irrigación y alimentación enteral con abrazadera para palo de gotero, programable
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 197

Pump Set Dislodged Error

The PUMP SET DISLODGED screen will appear if the black ring retainer (MISTIC) is not properly
loaded in the MISTIC pocket in the pump set loading area. Check and correct the positioning of
the MISTIC retainer if possible. If the error cannot be resolved, load a new pump set, prime it,
and restart the feeding, Figure 31.
If the error cannot be resolved, press
different pump into service
Figure 32 Battery Low error screen.
Indicates that the battery must be
recharged immediately.

Feeding Complete

(Information)
The FEEDING COMPLETE information screen appears after completion of the programmed
feeding, Figure 33. Press
the SET LOADED opening menu, Figures 7A-7D.
Figure 34. Running screen with
the > 24 HRS of Pump Set Usage
indicator in upper left of the screen.

LED Array

The pump status LED array on the upper right of the pump gives a quick visual indication of the pump status, especially in
darkened rooms.
A green light status indicates normal pump operation.
A yellow light status indicates an informational or warning situation for a low battery condition, the pump in HOLDING mode, or one
of the following medium priority alarms: LOW BATTERY ERROR, HOLD ERROR, FEED ERROR, FLOW ERROR, and FLUSH ERROR.
A red light status indicates a high priority alarm. The screen will show one of the following error messages: SYSTEM ERROR, PUMP
SET DISLODGED, or ROTOR ERROR
Kangaroo™ ePump™ Enteral Feed and Flush Pump with Pole Clamp
(High Priority Alarm)
POWER to stop operation of the pump and put a
.

Battery Low

(Medium Priority Alarm)
The BATTERY LOW screen appears and the alarm beeps continuously when the battery needs to be
recharged. There is approximately 30 minutes of battery life remaining when this screen appears,
Figure 32.
Plug the A/C power adapter in to begin recharging. The pump will automatically return to the
screen that was active prior to the error. The battery will charge continuously whenever the pump
is plugged into a wall outlet. Eight hours of charging is required to fully recharge the battery pack.
Power Down to turn off the pump. Press
4
Pump Set Use >24 Hours Warning
The pump set usage warning indicator will blink on the RUNNING screen if a pump set has been
used for 24 or more hours (hours actually running). It is recommended to replace pump sets after
this length of usage. This icon is only an informational message and does not require action.
Figure 34 shows an example of the RUNNING screen, where a feed & flush set has been in use for
more than 24 hours. The informational warning indicator shows up in the upper left on the screen
.
CONTINUE to return to
4
30
Figure 31. Pump Set Dislodged
Error screen.
Figure 33. Feeding Complete
notification screen.
Table of Contents
.

Publicidad

Tabla de contenido
loading

Tabla de contenido