The Timer - NEFF T43D1 N Instrucciones De Uso

Once the time has elapsed
Correcting the time
Switching off the automatic
OFF function
Suggestions and warnings

The timer

It is programmed as
follows
Once the time has elapsed
54
The hotplate switches off once this time has elapsed.
You will hear a beep.
The 0 indicator will appear on the hotplate display and
00
will appear on the time program display. The R
indicator flashes.
When the Ò symbol is pressed, the indicators go out
and the beep stops.
Select the hotplate and then press the Ò symbol.
Modify the cooking time using the + or - symbols.
Select the required hotplate and press the Ò symbol.
Then press the - symbol until kk is displayed. The R
indicator goes out.
Select a hotplate to check the remaining cooking
time.
Any cooking time can be to programmed up to 99
minutes.
After a power cut, the time program function will no
longer be activated.
This can be used to time periods up to 99 minutes. It
is independent of the other settings.
1. Press the Ò symbol.
00 appears in the time program function display.
The Min. and Q indicators light up.
2. Press the + or - symbols.
A recommended value is displayed.
+ symbol: 10 minutes
- symbol: 05 minutes
3. Set the time using the + or - symbols.
After a few seconds, the Min. indicator dims and the
timer starts to count down.
A beep sounds. 00 appears in the time program
function display and the Q indicator flashes.
Press the Ò symbol. The indicators go out and the
warning beep stops.