Installation; Stroke Programming Sequence; Programming Sequence To Time Work; Without Encoder And With Safety Edge - Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador

commands and safety protections status mode.
To immediately exit test mode just press the "TEST"
button again.
7

Installation

It is necessary to programme the stroke to allow the
correct operation of the control panel.
WARNING! Before proceeding, make sure that:
• The direction of rotation of the motor has been
correctly selected with the parameter
extended mode)
• For safety position the leaf in an intermediate
position in such a way as to have time to stop the
motor in case it moves in the wrong direction.
• The safety protections connected are at rest
and those not present are electrically bridged or
excluded by the related parameter.
• You cannot enter programming mode if one of the
safety protections is active. The display changes to
TEST mode and displays the input that is in a state
of alarm and which prevents you from proceeding.
• You cannot enter programming mode if you
have enabled the "man present" mode (para.
A7 01 AP PE
),
NOTE:
• It is mandatory to have a gate stop when opening
and closing.
• 6-pole motors turn at a slower rate than 4-pole
ones: for them, therefore, parameter
have maximum value
addition, parameters
60
value of less than
• Programming is interrupted (with error
AP PE
message
- The TEST button is pressed.
- One of the safety protections (photocells,
safety edges, STOP button) is turned on.
In such an event you have to repeat the
programming of the stroke.
7.1
Stroke programming sequence with
encoder enable
WARNING!
• The stroke measurement takes place during the
closing phase.
• If the limit switch are connected, the motion
stops when they are activated, otherwise it stops
on the gate stop.
• Programming is performed with the speed slowed
26
0-
will appear on the display.
41
01
(factory standard). In
42 43
and must have a
.
) in the following situations:
down as set in parameter
To enter programming press the PROG button for 4
s.: the display will show
you can programme the stroke by pressing the
PROG button again, or by pressing the radio control
button enabled by the step-by-step function.
Press PROG (o PP): programming is performed in a
fully automatic way: wait for completion avoiding
crossing the ray of the photocells or activating other
safety devices (safety edges, stop).
71
( in
The display shows the indication
starts to open when the leaf is in the fully open
position, the writing
display for 2 seconds indicating that it is going to
close again, then the indication
flashing and the closing manoeuvre starts.
If programming is completed properly, the display
returns to the status of the commands and the
safety protections.
Otherwise
and programming needs to be repeated.
7.2

Programming sequence to time work

without encoder and with safety edge

WARNING!
• Programming the work time takes place during
the closing phase
• The safety time margin is automatically added by
the control unit.
must
To enter programming press the PROG button for 4
s.: the display will show
you can programme the stroke by pressing the
PROG button again, or by pressing the radio control
button enabled by the step-by-step function.
Press PROG (or PP): starts to open
on the display, when leaf 1 has reached the opening
limit switch
2 seconds the closing manoeuvre automatically starts
CH1
and appears on the display. Once the closing
limit switch has reached the programming is finished.
If programming is completed properly, the display
returns to the status of the commands and the
safety protections.
Otherwise
and programming needs to be repeated.
41
AP P-
AU tO
AP PE
(error when learning) appears
AP P-
PA
appears on the display flashing, after
AP PE
(error when learning) appears
in extended mode.
; at this point,
AU tO
and
flashes on the
AU tO
stops
; at this point,
ap1
, appears