ENGLISH
Sleeve Applicator Setup
1. Attach free end of the pneumatic hose that is
attached to an air compressor to the male
connector on the BSP45 unit. MAKE SURE
THE PNEUMATIC LINE IS FREE OF OIL.
Note:
Air pressure must be greater than
40 psi but less than 145 psi.
1
3. Attach the power cord (included) to the applicator and plug into an electrical outlet, then flip the
electrical switch on the back of the applicator to the ON (I) position.
3
2/25/16
Sleeve Applicator Setup
2. Plug in the foot pedal.
2
BSP45 User's Manual
3