Brady BSP45 Manual Del Usuario página 26

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

16
Troubleshooting
Issue/Error Code
Miscellaneous Issues
Machine does not power up
Machine stopped
Machine not opening sleeves
Machine does not open every
sleeve
Cannot close front cover
Slow operation
BSP45 User's Manual
Problem
Switch not activated
Blown fuse
Mandrel not correctly installed
Dies not installed correctly
Foot pedal not plugged in
Dies not installed correctly
Sensor windows are dirty
This operation requires the use
of both hands
Low air pressure
ENGLISH
Solution
Ensure E-Stop is not activated.
Ensure doors are closed and
the rear power switch is on.
Ensure fuse in rear power
switch is not blown. If it is,
replace with new fuse.
Open doors and ensure
mandrel screw is tight. If not,
use a #1 Phillips screw driver
to tighten the screw.
See the "Changing Dies/
Sleeve Size" section
to verify the dies are properly
installed.
Ensure foot switch is plugged
in.
See "Changing Dies/Sleeve
Size" section
(page
4) to verify
the dies are properly installed.
See "Cleaning the Applicator"
section on
page 12
of this
manual.
• Ensure that the tractor
feed door is closed.
• Then, with one hand,
push and hold the front
door release lever while
closing the cover door
with the other hand.
• Release the lever when
the front door is closed.
Ensure that the air pressure is
40psi to optimize performance
of machine.
(page
4)
2/25/16

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido