18
Appendix A - Loading Material on BBP72 Printer
Appendix A - Loading Material on BBP72 Printer
1. To load the 1" & 2" sleeves and cardstock into the BBP72, orient the notch on the edge of the
carstock (marked with the red arrow) towards the interior wall of the unit. The blue lines on the
cardstock should face up coming off of the roll.
2. Print the data onto the sleeves, starting with the data for Sleeve #1.
1
3. After printing, rewind the roll. The last sleeve printed will be the first onto the rewinder. This
places the sleeve material in the correct orientation to run on the BSP45 Printed Sleeve #1 will
be on the outside of the rewound roll and the first sleeve into the BSP45.
BSP45 User's Manual
ENGLISH
2/25/16