ENGLISH
Appendix B - Loading Material on PR300+ Printer.
Template Side #1 (first side to print for 1- and 2-sided printing)
1. To load the 1" & 2" sleeves and cardstock into the PR300+, orient the notch on the edge of the
cardstock (marked with the red arrow) away from the interior wall of the unit. The blue lines on
the cardstock should face DOWN coming off of the roll.
1
2. For 1-sided print, print the data onto the sleeves, starting with the data for Sleeve #1. Then,
after printing, rewind the roll with the last sleeve printed being the first onto the rewinder. This
places the sleeve material in the correct orientation to run on the BSP45.
OR
For 2-sided print, print the data onto the sleeves, starting with the data for the LAST sleeve.
Then, rewind the roll directly out of the printer so that the data on Sleeve #1 is now on the
outside of the roll.
2/25/16
Appendix B - Loading Material on PR300+ Printer. 19
BSP45 User's Manual