Changing Mandrel - Brady BSP45 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH

Changing Mandrel

Install the mandrel that corresponds to the chosen sleeve diameter. The sleeve diameter is stamped
on the side of the mandrel block.
Note:
If only changing the mandrel (not the dies), the Function button does
not have to be pressed.
For this procedure, you will need a #1 drive Philips head screw driver.
1. Open the access door to display the mandrel
assembly.
1
3. Pull out the installed mandrel assembly.
3
2/25/16
Changing Mandrel
2. Unscrew the mandrel holder with the Philips
head screw driver.
2
4. Insert another mandrel assembly
(corresponding to the size previously
selected on the bezel and as indicated by
the dies) and secure by tightening the
screws.
4
BSP45 User's Manual
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido