Bowa ErgoLAP Manual Del Usuario página 34

3.5.2. Assembly
3.5.3. Disassembly
 Carry out in reverse sequence
14
B Inner shaft tube
C Outer shaft tube
C1 Sealing (blue)
Step 1:
 Install C1 onto C.
Step 2:
 Introduce B into C.
Step 3:
 Introduce B/C into D and hand-
tighten each.
Step 4:
 Introduce A.
 Push A in until audible latching
occurs. If necessary, press D1
slightly.
 Latching noticeable
 Align A as required. For this, turn A
until further latching is heard. To
facilitate this, operate D.
 Check firmly seated.
Step 5:
 Operate D.
 A must close together completely.
 A may not be kinked or bent.
E HF cable
 Check firmly seated.
MN030-667-S2 EN