Work And Safety Instructions - Festo MPS 8059892 Descripción Breve

Programming station
®
The MPS may only be used:

For its intended purpose

When its safety functions are in perfect condition.

5 Work and safety instructions

General

Trainees should only work with the circuits under the supervision of an instructor.

Electrical devices (e.g. power packs, compressors and hydraulic units) may only be operated in training
rooms that are equipped with residual current devices (RCDs).

Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!

Malfunctions which might impair safety must not be generated when the device is operated for training
purposes.

Wear personal safety equipment (safety glasses, safety shoes) when working on circuits.
Mechanical safety

Switch off the power supply!
– Switch off the working and control power before working on the circuit.
– Only reach into the setup when it's at a complete standstill.
– Be aware of potential overtravel times for the drives.

Mount all of the components securely on the profile plate.

Make sure that limit valves are not actuated from the front.

Risk of injury during troubleshooting!
Use a tool such as a screwdriver to actuate limit valves.

Set all components up so that it's easy to activate the switches and interrupters.

Follow the instructions about positioning the components.
28
Malfunctions which may impair safety must be eliminated immediately!
© Festo Didactic 8059913