Swing-N-Slide Timber-Bilt Turbo Tube Slide Instrucciones De Ensamble página 18

ASSEMBLY INSTRUCTIONS
2" x 6" x 90"
18
FIGURE 3
2" x 6" x 45-1/2"
2" x 6" x 33-3/4"
(2) 2" x 6" x 37-1/4"
4" x 4" x 120"
TOWER INSTALLATION (cont.)
7. Attach two 2" x 6" x 37-1/4" and one
2" x 6" x 32-3/4" spacer boards to the
unit as indicated in Fig. 3 using four 3"
screws per joint.
8. Attach the 2" x 6" x 90" and 2" x 6" x
45-1/2" boards to the top of the unit
using four 3" screws per joint.
9. Position two 4" x 4" posts to the
2" x 6" x 40-1/4"
assembly as indicated. Attach at the
top and bottom using four 3" screws
per joint.
10. Attach 2" x 6" x 40-1/4" to the top of
the posts using four 3" screws per
joint.
11. Using the existing bolt holes as a
guide, drill 3/8" holes through the
previously attached 2" x 6" x 90" top
board. Secure each joint using a
5" carriage bolt, wood loc washer,
washer and loc nut.
12. Drill 3/8" holes through the remaining
2" x 6" and 4" x 4" joints as indicated.
Counterbore the 4" x 4" approximately
1/2" deep at the hole locations. Secure
each joint using a 5" carriage bolt,
wood loc washer, washer and loc nut.
4" x 4" x 120"