Swing-N-Slide Timber-Bilt Turbo Tube Slide Instrucciones De Ensamble página 36

ASSEMBLY INSTRUCTIONS
FIGURE 11
2-3/4" bolt
2-3/4" perno
boulon de 2-3/4 po
washer
arandela
rondelle
3"
36
2-3/4" bolt
2-3/4" perno
boulon de 2-3/4 po
washer
arandela
rondelle
washer
loc nut
arandela
tuerca
rondelle
écrou
de blocage
washer
arandela
2-1/2" lag bolt
rondelle
pernos de retraso de 2-1/2"
tire-fond de 2 1/2 po
1-1/2" lag bolt
pernos de retraso de 1-1/2"
tire-fond de 1 1/2 po
MOUNTING SLIDE
1.
2.
3.
washer
arandela
rondelle
4.
loc nut
tuerca
écrou de
blocage
5.
6.
7.
SLIDE BASE
1.
FIGURE 12
The help of at least one other individual
will be required for mounting the slide.
Insert the 2-3/4" bolts through a washer,
through previously drilled 3/8" holes in the
upper rail of the unit (see FIGURE 11).
Carefully lift the slide assembly to the
opening of the unit. Place the mounting
panel/slide assembly on the 2-3/4" bolts
previously inserted (see FIGURE 11).
Place washers and loc nuts on the bolts
and hand tighten.
Adjust the mounting panel/slide assembly
until the holes of the mounting panel align
with the previously drilled pilot holes.
Attach the top corners of the mounting
panel/slide assembly first using a 2-1/2"
lag bolt and washer . Secure the
remainder of the panel/slide assembly to
the unit using 1-1/2" lag bolts and
washers at each open hole location (8 are
required).
Tighten the 2-3/4" bolts securely.
Attach the bottom corners of the mounting
panel/slide assembly using a 2-1/2" lag
bolt and washer.
Remove approximately 3" of grade
directly beneath the base of the slide.