Warnings; Preliminary Safety Information - Ravaglioli RAV TD4400 Serie Instrucciones Para El Uso

RAVAGLIOLI S.p.A.
WARNING: This section includes the instructions for use of RAVTD4400
"wheels track alignment integrated with the lift" system. Please, refer also to
the instructions for use and maintenance of the lift RAV 640.2.46 TD /RAV
640.2.52 TD part No.0586-M006-0 in section 2.
used under licence by RAVAGLIOLI S.p.A.

0 WARNINGS

Any damage caused by failure to observe the indications in this manual or by incorrect
machine use shall exempt Ravaglioli S.p.A. from all liability.

0.1 Preliminary safety information

Before starting up the appliance:
•
Read the instructions and the entire manual before using or working on the wheel
aligner. This manual is an integral part of the product. Its aim is to provide the user
with instructions on how to operate the wheel aligner RAV TD4400. Look after the
manual for the entire working life of the machine and keep it in a place that is known
and easily accessible. Refer to it every time you have any doubts. All product
operators must be able to read the manual.
•
Make sure the power supply is in conformity with the specifications shown on the
plate. The plate showing voltage and frequency details is positioned on the rear of the
appliance. Please read this plate carefully. NEVER connect the appliance to a power
source with voltage or frequency different to those shown.
•
Adequately position the power cable of the wheel aligner. The machine features a 3-
pin plug with integrated ground. This can only be fitted in a socket that also has a
ground point. If it is not possible to fit the plug into this type of socket, contact an
electrician. Do not try modifying or using the plug incorrectly.
On switching off the machine:
• Never switch off the PC inside the machine by disconnecting the plug or by means of
the PC switch itself. Always follow the procedure described in para. 4.2 on page 10 .
Incorrect PC switch-off can "corrupt" the files inside the HARD-DISK.
In emergency conditions and before any maintenance jobs:
•
Isolate the machine from any power sources by means of the master switch and
disconnect the plug from the power socket.
•
Do not try servicing the machine arbitrarily because the opening and removal of the
doors could expose you to hazardous voltages; maintenance jobs must only be
performed by authorised after-sales service personnel.
Working environment and cleaning the machine:
•
The working environment must be kept clean, dry and not exposed to atmospheric
agents and must be well lit.
•
Do not clean the machine with jets of water and compressed air.
To clean the plastic panels or shelves, use a damp cloth (avoid using liquids
containing solvents).
RAVAGLIOLI S.p.A. shall be entitled to make any changes to the models described in this
manual for technical or commercial reasons.
Page 2/ 15 RAVAGLIOLI S.p.A. – 40044 Pontecchio Marconi (BO) Via I Maggio, 3
The Bluetooth trademarks belong to their respective owners and are
Tel. (+39) 051/ 67.81.511 – Fax (+39) 051/ 84.64.67
e-mail: rav@ravaglioli.com
RAV TD4400
/http www.ravaglioli.com
OPERATOR'S MANUAL
Code M0150 - rev.1.0
(01/2008)