Progress PBN 1110 Manual De Instrucciones página 10

10 progress
Wipe the oven with a soft cloth which is
washed out in warm soapy water after every
use. From time to time a more thorough
cleaning is required. Use a commercially
available oven cleaner for this.
Replacing the oven light
Important! Separate the appliance from
the power supply by switching off the
fuse.
If the oven bulb needs replacing, the new
bulb must have the following specifications:
– Electric power: 15W / 25W
– Electrical rating: 230 V (50 Hz)
– Heat resistance up to 300 °C
– Connection type: E14
These replacement bulbs can be purchased
from your dealer.
To change the oven light:
1. Before proceeding ensure the oven is
cool and is disconnected from the elec-
tricity supply.
2. Push in and turn the glass cover anti-
clockwise
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the elec-
trical supply.
The oven door
The oven door consists of two panes of
glass. The oven door can be disassembled
and the internal panes can be removed to
make cleaning easier.
Warning! Remove the oven door before
cleaning it. The oven door could abruptly
close if you try to remove the internal
panes of glass when the door is still
assembled.
To do so, proceed as follows:
1. Open the door fully.
2. Locate the two door hinges
3. Lift and turn the levers on the two hinges
4. Hold the door by the side edges and
close it slowly but not COMPLETELY
5. Pull the door forward, removing it from its
seat
6. Place the door on a stable surface pro-
tected by a soft cloth to prevent the han-
dle surface from being damaged