Menu Description - salmson NEXIS Advens 2 Instalacion Y Puesta En Servicio

English
Symbol

8.3.5 Menu description

List (Fig. A7)
<1.0.0.0>
Position
OPERATION
SERVICE
• To adjust the setting point, turn the encoder. The
display changes to menu <1.0.0.0> and the set-
point begins to blink. The new rotation (or a new
action on arrows) allows increasing or decreasing
of the value.
• To confirm the change, give an impulse on the
encoder, the display returns to the status page.
<2.0.0.0>
Position
OPERATION
SERVICE
• The operating modes are the « Speed control »,
the « Constant pressure » and the
« P.I.D. control ».
<3.0.0.0>
Position
OPERATION
SERVICE
<4.0.0.0>
Position
OPERATION
SERVICE
• The « Information » menu displays measuring,
device and operating data, see, (Fig. A8).
44
Description
When the arrow appears:
• An impulse on the encoder allows
the access to the submenu (exam-
ple 4000->4100).
When the arrow « return »" appears:
• An impulse on the encoder allows
the access to the higher menu
(example 4150->4100).
Switch 1 Description
OFF
Adjustment of the setting
point, possible for both
cases.
ON
Switch 1 Description
Only on reading for ope-
OFF
rating modes.
Setting for operating
ON
modes.
Switch 1 Description
OFF
Setting ON / OFF of the
pump.
ON
Switch 1 Description
OFF
Only reading for the
« Information » menu.
ON
<5.0.0.0>
Position Switch 1
Only reading for the
OPERATION OFF
« Service » menu.
Setting for « Service »
SERVICE ON
menu.
• The « Service » menu allows to get access to the
converter parameter setting.
<6.0.0.0>
Position Switch 1
OPERATION OFF
Display of the error page.
SERVICE ON
• If one or several defects arise, the page of
defects appears.
The letter « E » followed by three digit code
appears (chapter 10).
<7.0.0.0>
Position Switch 1
OPERATION OFF
Display of « Access lock »
symbol.
SERVICE ON
• The « Access lock » is available when the switch
2 is in the ON position.
CAUTION! Material damage!
Inadequate setting changes can lead to pump
operation defects, which can lead to material
damage on the pump or installation.
• Settings in « SERVICE » mode should only be
made during commissioning and only by skilled
technicians.
POMPES SALMSON SAS 09/2013
Description
Description
Description