Sensor Installation; General Information - Siemens SITRANS F Serie Manual De Usuario

Save/Rename Site procedure
Whenever new site configurations are added to an existing site that site must be saved again
to retain the new site changes.
1. To save all programmed data to site, press <Left Arrow> and then scroll up to [Channel
2. Press <Right Arrow> and scroll to [Save/Rename Site].
3. Press <Right Arrow> and then <ENT> to save all programmed data to site.
4. To return to the top menu level, continue to press the <Left Arrow> key.
5. Sensors can now be mounted.
3.5

Sensor Installation

3.5.1

General information

Reflect and Direct Mounting Modes
Reflect and Direct mounting modes are supported for clamp-on sensors. The transmitter
recommends a mounting mode after analyzing your pipe and liquid data entries. This Quick
Start illustrates a typical sensor setup using the Reflect Mode.
Note
For Direct Mount refer to the Operating Instructions manual.
FUS1010 IP65 NEMA 4X
Operating Instructions, 7/2010, A5E03086486-02
Setup].
①
The saved site name now appears in the menu screen.
Connecting
3.5 Sensor Installation
29