Figure 3-9 Sensor; Figure 3-10 Sensor Installation - Siemens SITRANS F FST020 IP65 NEMA 4X Instrucciones De Servicio

Installing the Sensor
1. Apply a continuous 3mm (1/8-inch) bead of couplant compound across the center (the
FST020 IP65 NEMA 4X Quick Start
Operating Instructions, 08/2014, A5E03086489-AJ
long way) of the sensor emitting surface.
①
Coupling Compound
②
Emitting Surface
③
Back End
Figure 3-9 Sensor
①
7ME39600M
Mounting Frame
②
Spring Clip (not
present on all
models)
③
Sensor Clamping
Screw
④
1012BN Spacer Bar
Figure 3-10 Sensor Installation
④
Sensor
⑤
Angled Edge
⑥
F-Connector
⑤
Mounting Strap. Note: Optional 2nd Mounting Strap may be
needed for additional support on larger pipes, over 76cm (30
inches).
⑥
Index holes
⑦
Spacer Bar REF hole
⑧
Orientation of sensor at 9 o'clock position
Connecting
3.3 Installing the Sensor
31