Operating Modes - Starmix GS H-1150 ATEX Zone 22 Instrucciones Para El Manejo

EN
– The power cable may only be replaced by an electrician. If the power cable must be replaced, you will
need to unscrew the handle on the motor head. Ensure the earth conductor is properly installed. The
cable may only be replaced by an equivalent cable:
230 volt models: H07 RN-F 3G 1.5 mm² 16 A
– This device has a cable with an earth wire and earthing plug. The plug must be connected to a suitable
power socket that is installed and earthed in compliance with local standards and regulations. Connec-
ting the earth wire incorrectly can increase the risk of an electric shock. Consult a certified electrician or
qualified professional if you are unsure if the mains power is properly earthed. Never modify the device
and the
included plug. If it cannot be connected to your mains, a suitable power socket must be installed by a
licensed electrician.
– Using extension leads is prohibited.

Operating modes

Operating Description
mode
Off Suction motor off
On Suction
The model has a combination ON/OFF switch.
After first pressing this switch, the motor will start with a delay of approx.
3-4 sec and the vacuum cleaner is ready for use. Pressing the switch again
will switch the device off.
ATTENTION - Duty cycle:
The use of an EC motor free from ignition sources makes the industrial vacuum suitable for continuous
duty
Position the vacuum cleaner near the area to be cleaned and activate the wheel lock.
Please note, the suction hose must be properly cleared before switching off or it may emit dangerous
substances after the device has been switched off.
26
Switch position
0
I
Model variant
1)