Ravelli Mia 90 Manual De Uso Y Mantenimiento página 167

Warning Pop -Up
ANOMALY
PUT THE FOOD IN THE
OVEN
TAKE THE FOOD OUT
OF THE OVEN
COOKING TIME
SERVICE REQUEST
ALARM
ANOMALY (general)
Alarms (table with reference codes)
TITLE
AL 01 BLACK OUT
FLAME PROBE
AL 02
FAILURE
OVERTEMP.
AL 03
FLAME
FUME
AL 04 EXHAUST
DAMAGED
NO SWITCH-
AL 05
ON
Use and maintenance manual Mia 90
DESCRIPTION
The oven has reached the set temperature, and you can start cooking.
The cooking timer is complete and you can take the food out.
You must set the cooking time.
The threshold value of set work hours has been reached. The symbol displayed
remains active throughout the work phase. Non-routine maintenance is required
on the cooker.
The cooker is in alarm state; refer to the troubleshooting chapter.
The cooker reported a problem (e.g: doors open). Press
message;
REASON
No voltage during work phase
The flame probe is malfunctioning
The flame probe is disconnected from the
electronicboard
Combustion in the brazier is not optimal due to
clogging or obstructions of internal stove ducts
inside the stove
Fume exhaust encoder is not working or is
connected incorrectly
No power to fume extractor.
The fume extractor is blocked.
The pellet tank is empty.
Pellet calibration and suction during switch on
phase
is incorrect.
The ignition coil is faulty or positioned
incorrectly
SOLUTION
Press the switch off key and switch on the stove
again
If the problem persists, contact the Support Service
Contact the Support Service
Contact the Support Service
Switch off the stove, clean the brazier and the tube
bundle and adjust the combustion setting the Pellet/
Air values
Contact the Support Service
If the problem persists, contact the Support Service
Contact the Support Service
Contact the Support Service
Contact the Support Service
Check for the presence of pellets in the container.
Top up, if necessary.
Contact the Support Service
Contact the Support Service
Rev.2 03/03/2021
Pag.46
to display the