SICK LCU-P Manual De Instrucciones página 356

Chapter 10
Code Fault Message
1 1 4 LOCKOUT: 114
CHANGE CONTROLBOARD
1 1 5 LOCKOUT: 115
CHANGE CONTROLBOARD
116 LOCKOUT: 116
CHANGE CONTROLBOARD
117 LOCKOUT: 117
CHANGE CONTROLBOARD
118 LOCKOUT: 118
CHANGE CONTROLBOARD
119 LOCKOUT: 119
CHANGE CONTROLBOARD
120 LOCKOUT: 120
CHANGE CONTROLBOARD
121 LOCKOUT: 121
CHANGE CONTROLBOARD
122 LOCKOUT: 122
CHANGE CONTROLBOARD
123 LOCKOUT: 123
CHANGE CONTROLBOARD
124 LOCKOUT: 124
CHANGE CONTROLBOARD
125 LOCKOUT: 125
CHANGE CONTROLBOARD
126 LOCKOUT: 126
CHANGE CONTROLBOARD
127 LOCKOUT: 127
CHANGE CONTROLBOARD
1 2 8 LOCKOUT: 128
CHANGE CONTROLBOARD time frame, the other channel was reset.
1 2 9 LOCKOUT: 129
CHANGE CONTROLBOARD
130 LOCKOUT: 130
CHANGE CONTROLBOARD
131 LOCKOUT: 131
CHANGE CONTROLBOARD
132 LOCKOUT: 132
CHANGE CONTROLBOARD
1 3 3 LOCKOUT: 133
CHANGE CONTROLBOARD
356
Diagnostic Messages
Fault Description
Input latch test failed.
Mode select 1 hardware failure.
Mode select 3 hardware failure.
Internal restart input hardware failure.
Auxiliary input A1 hardware failure.
Auxiliary input B1 hardware failure.
The ROM CRC check has failed.
Testing of CPU registers failed.
A test of the LCU-P OSSD failed.
Power supply monitor over voltage test failed.
Power supply monitor under voltage test failed.
A fault occurred during the opcode test.
Primary AOPD OSSD 1 is stuck high.
Secondary AOPD OSSD 1 is stuck high.
Channel sequence pulse did not occur in the correct
External RAM cell test failure.
Communications between safety channels has failed.
Safety control channels running different modes.
One channel is not sending information as requested.
One channel has not sent configuration information
as requested.
8 008 364/NB 86/25-04-00 © SICK AG • Safety Systems • Germany • All rights reserved
Operating instructions
LCU-P