Grundindstilling, Setup - SICK LCU-P Manual De Instrucciones

Kapitel 7
Programm access
Select Funktion
100
Change Set up
Define User Mode
ENTER
Language
S1
English French
S2 Measurement Units
Inches
S3 Receiver 1/2
Type 4/none Type 4/Type 4
Type 2/none Type 2/Type 2
S4 Receiver 2 Restart
With Receiver
S5 Reset Switch
Press and release
S6 Alternate Restart Break
Alternate Restart–> no Alternate Restart–> yes
S7 Restart Timer Break
Restart timer Break - none
Cycle Contact Time Break
S8
Cycle I/O limited
S9 Sensor Test
PSSD not tested
S10
98 8 008 364/NB 86/25-04-00 © SICK AG • Sikkerhedsteknik • Tyskland • Alle rettigheder forbeholdes
Programmering
7.2 Grundindstillinger, setup
Run Modes
ESC
German
Millimeters
Type 4/Type 2
Type 2/Type 4
Restart Interlock
Latched
Restart timer Break - 28s
Gennemgang
af alle grundind-
stillinger med
Cycle I/O unlimited
PSSD tested on I/O Break
S10 System Test
Test Contact N.C.
S11 Relay Monitor
Relay Monitor - yes
S12 Auxiliary Inputs
No muting Mute = A1 & A2
S13 Muted Inputs
No muted receivers Receiver 1
Both Receivers
S14 Muting Timer
No muting timer
S15 New Access Code
No
S16
* * *
1234567890<>#
S17
Confirm Set Up
100 Select Function
Change set up Define User Mode
ESC
S1 U1, (2), (3)
000 Keypad Enabled
Aktiver driftsv æ lger
LCU-P driftsklar
Driftsvejledning
S9
Test Contact N.O.
Relay Monitor - no
Mute = A1&A2 or B1&B2
Receiver 2
Vælg tiden 0 - 300 sek.
med
Muting limit s
Yes
Fastlæg 3-cifr.
kodetal. Bekræft
ved at vælge #-
tegnet og ENTER
1234567890<>#
ENTER (save)
Run Mode
R1
LCU-P