Turning The Ups Off; Initiating The Self-Test - Eaton Powerware 9125 Guia De Instalacion

OPERATION

Turning the UPS Off

NOTE Pressing the Off
down immediately.
To turn off the UPS:
1.
2.
3.

Initiating the Self-Test

NOTE The batteries must be fully charged and the UPS must not be in Battery mode to
perform the self-test.
Press and hold the
During the five-second test, the bar graph indicators cycle through twice.
If the alarm beeps or a UPS alarm indicator stays on, refer to
"Troubleshooting" in the Powerware 9125 Two-in-One UPS
(2500/3000 VA) User's Guide.
32
EATON Powerware
button while the UPS is in Battery mode causes the UPS to shut
Prepare your equipment for shutdown.
Press and hold the Off
The UPS transfers to Standby mode (if utility power is available) and
removes power from your equipment.
Unplug or remove utility power from the UPS; the UPS shuts down
in five seconds. All front panel indicators flash briefly prior to
shutdown.
If you do not unplug or remove utility power from the UPS, it
remains in Standby mode.
button for three seconds to initiate the self-test.
®
9125 (9910-P30) UPS Installation Guide for IBM
button for approximately three seconds.
® S
Applications 164201636 Rev A