Kit Assembly - Metra 99-3016G Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the pocket to the radio brackets
with (4) of the supplied #8 x 3/8"
Phillips screws. (Figure A)
2. Attach the bracket/pocket assembly to
the radio trim panel with the remaining
(4) #8 x 3/8" Phillips screws. (Figure B)
3. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
4. Slide the radio into the bracket trim
panel assembly and secure with the
screws supplied with the radio.
(Figure C)
5. Clip the climate controls into the radio
trim panel assembly.
6. Clip the climate control vents into the
radio trim panel assembly.
7. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
8. Reassemble the dash in the reverse
order of disassembly.

Kit Assembly

(Figure A)
99-3016G
(Figure B)
3
(Figure C)