Promise Technology VTRAK S3000 Guia De Inicio Rapido página 21

Step 3: Hostname
When you click the Next button in the Configure VTrak dialog box, the Warning
dialog box appears. At this phase of the system setup, you have no storage
configured. Therefore, the warning does not apply.
1. In the dialog box, click the OK button to continue.
The Set Hostname dialog box appears.
2. In the dialog box, do one of the following actions:
• Click the Cancel button to accept the Present (default) hostname.
• Enter a new hostname for the VTrak appliance and click the OK button.
When you click the OK button, the network server automatically restarts.
That action drops your connection. Wait two to three minutes, then try to log
in. If you cannot log in, wait another minute and try again.
To see the new hostname as the Present hostname in the Set Hostname
dialog box, you must reboot the appliance.
When you log in, the Configure VTrak dialog box appears, ready for Step 4.
If you plan to change the hostname, do so before you connect to
your storage devices.
If your storage is set up already and you change the hostname,
you must reconfigure your storage to recognize the new
hostname.
Task 3: Configuring the VTrak Appliance
Caution
21