Promise Technology VTRAK S3000 Guia De Inicio Rapido página 66

VTrak S3000 Quick Start Guide
The wizard automatically creates a configuration repository on the
secondary server.
Click the Next button to continue.
The Users List opens.
5. In the Users List, examine the user names for both VTrak appliances.
• If all names are identical, click the OK button.
• If any names are different, click the Cancel button and modify the user
accounts as necessary.
If you clicked the OK button, the Select Failover Subnets dialog box opens.
6. In the dialog box, check the box beside the subnet for your servers.
The subnet should match the IP addresses of both VTrak appliances in the
first three octets. For example, if your VTrak appliances use IP addresses
192.168.250.160 and 192.168.250.170, then the subnet is 192.168.250.0.
Click the Next button to continue.
The Enter the IP addresses of the Servers dialog box opens.
7. In the dialog box, complete the IP addresses of your VTrak appliances.
Clients use these IP addresses to access the VTrak appliances.
Click the Next button to continue.
The Enter the Health Monitoring IP addresses of the servers dialog box
opens.
8. In the dialog box, complete the Health Monitoring IP addresses of your
VTrak appliances.
Enter the IP addresses from "Configuring Network Connections" on page 64.
Click the Next button to continue.
The Set WWPN Ports dialog box opens.
9. In the dialog box, choose the secondary standby WWPN from the dropdown
menu. As noted above, open the second Management Console now to verify
the WWPNs.
For a mutual failover, each iSCSI
VTrak appliance must know a corresponding secondary standby WWPN of
an adapter in the other VTrak appliance. Refer to the General tab of each
adapter to view its WWPN.
The four secondary standby WWNN dialog boxes look virtually
identical. Be careful to click the Next button one time only as you
move through the dialog boxes and make your settings.
or Fibre Channel
Caution
66
adapter in one