Promise Technology VTRAK S3000 Guia De Inicio Rapido página 64

VTrak S3000 Quick Start Guide
The Enable Configuration Repository wizard opens.
Click the Next button to continue.
The S elect Physical Resource(s) for the Virtual Device(s) dialog box opens.
2. In the dialog box, check the physical devices you prepared in the previous
steps, and click the Next button.
The Select a Physical Device dialog box opens.
3. In the dialog box, click the device you want and click the Next button.
The Create a Configuration Repository dialog box opens.
4. In the dialog box, verify your choice and click the Finish button.
On the VTrak server
shows Online .
The device icon changes from V
quorum device that contains the configuration repository.
Configuring Network Connections
You must create an IP address alias for Health Monitoring. Health Monitoring tells
each primary appliance (server) about the other appliance's condition and when
to assume a secondary function because its failover pair is offline.
You can use the same NIC (network) port chosen during setup. See "Changing
NIC Settings" on page 19. But you must create and use a separate IP address for
Health Monitoring.
To configure the network for failover:
1. In the Tree, right-click a VTrak server
Maintenance > Configure Network from the popup menu.
The Network Configuration dialog box opens.
2. In the dialog box, click the Config button.
The IP Address Configuration dialog box opens.
3. In the dialog box, click the Add button.
The Interfaces dialog box opens.
4. In the dialog box, enter a new IP address and the subnet mask, then click
the OK button.
icon General tab, Configuration Repository Status
When changes are done on one appliance (server), perform a
Rescan on the other appliance before continuing.
to Q/V to indicating this is the
Important
icon and choose System
64