Task 11: Configuring Storage on the Subsystem
Setting up your subsystem with WebPAM PROe consists of the following actions:
•
Logging into WebPAM PROe (below)
•
Choosing a Language (page 49)
•
Making Subsystem Settings (page 49)
•
Restarting the Subsystem (page 49)
•
Making Controller Settings (page 50)
•
Making Background Activity Settings (page 50)
•
Making Global Physical Drive Settings (page 51)
•
Making Individual Physical Drive Settings (page 51)
•
Configuring your Logical Drives (page 51)
•
Logging out of WebPAM PROe (page 54)
Logging into WebPAM PROe
1.
Launch your Browser.
2.
In the Browser address field, type in the virtual IP address of the VTrak
subsystem.
Use the virtual IP address you set in the CLI (page 42) or CLU (page 44).
Note that the IP address shown below is only an example. The IP address
you type into your browser will be different.
Regular Connection
•
WebPAM PROe uses an HTTP connection. . . . . . . . . . . . . . . .http://
•
Enter the VTrak's IP address . . . . . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
http://192.168.10.85
Secure Connection
•
WebPAM PROe uses a secure HTTP connection . . . . . . . . . .https://
•
Enter the VTrak's IP address . . . . . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
https://192.168.10.85
Whether you choose a regular or a secure connection, your login
to WebPAM PROe and your user password are always secure.
Task 11: Configuring Storage on the Subsystem
Note
47