Promise Technology VTRAK S3000 Guia De Inicio Rapido página 43

The settings above are included as an example. Your values will be different.
To make the Virtual Management Port network settings automatically , type
the following string, then press Enter.
administrator@cli> net -a mod -t mgmt -s "dhcp=enable"
Note that the IP address described above belongs to the VTrak subsystem,
not to an individual RAID controller. Use this IP address to log into the VTrak
over your network.
2. To verify the settings, type net and press Enter.
administrator@cli> net
===========================================
CId Port Type IP
===========================================
Virtual
Making Maintenance Mode Settings
Each RAID controller has an IP addresses for access when the controller
goes into maintenance mode . Maintenance mode is only for remedial action
in the event of a problem with one of the controllers. See the VTrak E-Class
Product Manual on the software DVD for more information.
To make the Maintenance Mode Network settings manually , type the
1.
following string and press Enter.
You must set each controller separately.
administrator@cli> net -a mod -t mgmt -m -c 1 -s
"primaryip=192.168.10.101, primaryipmask=255.255.255.0,
gateway=192.168.10.1"
administrator@cli> net -a mod -t mgmt -m -c 2 -s
"primaryip=192.168.10.102, primaryipmask=255.255.255.0,
gateway=192.168.10.1"
The settings above are included as an example. Your values will be different.
To make the Maintenance Mode Network settings automatically , type the
following strings and press Enter.
You must set each controller separately.
administrator@cli> net -a mod -t mgmt -m -c 1 -s "dhcp=enable"
administrator@cli> net -a mod -t mgmt -m -c 2 -s "dhcp=enable"
Note that the network settings above belong to individual RAID controllers.
Use these IP addresses only for remedial action when the subsystem is in
maintenance mode.
Mgmt 192.168.10.85 255.255.255.0 192.168.10.1
43
Task 10: Setting-up the Subsystem
Mask Gateway Link
Up