Autotare; Print Mode - RADWAG R Serie Manual Del Usuario

Balance ambient conditions
Parameter relating to ambient and environmental conditions in which the balance operates. There
are two options: STABLE and UNSTABLE. Selecting STABLE mode makes the balance work much
faster, i.e. weighing takes much less time than for UNSBABLE mode. If the ambient conditions are
unstable it is recommended to use UNSTABLE mode. By default, the parameter is set to STABLE
option.

11.2.5. AUTOTARE

Autotare is used for quick determination of net weight for loads with different tare values, wherein
they are measured one after another.
When the function is active (<AUTOTARE> parameter set to <YES> option), the operating process
takes the following steps:
•
Make sure that the weighing pan is empty and press button responsible for zeroing.
•
Put product packaging on a weighing pan.
•
After measurement stabilization, automatic taring of the packaging mass proceeds (Net
marker appears in the upper part of the display).
•
Put product that is to be packed into the packaging.
•
The display shows net weight of the product.
•
Take off the product together with the packaging.
•
The balance cancels tare value (packaging weight recorded in balance storage during the first
step of the operating process) after the gross weight value (set in <AUTO THRES> parameter)
has been exceeded.
•
Put packaging of the next product on a weighing pan, automatic taring of the packaging weight
proceeds after measurement stabilization (Net marker appears in the top section of the
display);
•
Put a next product that is to be packed.
For correct operation of the balance with AUTOTARE function, it is necessary to adjust the threshold
value.
<AUTO THRES> parameter is connected with the following functions:
•
automatic tare,
•
automatic operation,
No automatic taring takes place as long as the gross weight value stays within the range set in
<AUTO THRES> parameter.

11.2.6. Print Mode

Function designed to enable print mode setting, it activates
Print mode options:
•
<WHEN STAB>, for this option stable measurement result, along with the settings for
parameter <GLP PRINTOUT>, is sent to the printer port. On pressing
result is not stable (no
result to the port after reaching stability for the measurement.
marker on a display), the balance software sends the measurement
- 45 -
key.
key, when the