RADWAG R Serie Manual Del Usuario página 58

density determination
5 Beaker
6
Hanger
Kit intended for AS and XA balances.
1 Beaker base
2 Stand
3 Sinker
4 Beaker
5 Thermometer holder
6 Thermometer
Flexible connector
7
sinker
Installation procedure:
AS balances
CAUTION!
•
Components of density determination kit shall be stored in a respective box.
•
Weighing pans and sinker shall not be put directly on a table, this might cause their damage.
•
Weighing pans and sinker, if not operated, shall be put on an additional stand.
•
If the kit has been installed and -nuLL- message is displayed than the balance shall be loaded with
weights set (12). Thus prepared balance can be used for density determination.
11 Additional stand for a set of pans or a sinker
Additional
12
determination of solids with density lower that density
of water
8 Hanger
9 Top weighing pan for solids density determination
10 Flexible connector for weighing pans
11 Bottom weighing pan for solids density determination
12 Additional sinker
13 Additional stand for a set of pans or a sinker
for Additional set of weighing pans for density determination of
14
solids with density lower that density of water
- 58 -
set of weighing
PS balances
pans for density