Further Information - BONFIGLIOLI Vectron Agile Manual Del Usuario

Display actual values
R.m.s Current [A]
Output Voltage [V]
Active Power [kW]
Actual Speed [min -1 ]
Actual frequency [Hz]
Current Error
Warnings
Last Error
Optional communication modules
RS485, Modbus oder VABus:
RS232, Modbus oder VABus:
Profibus-DP:
CANopen
VABus/TCP:
EtherCAT:
ProfiNet:
Modbus/TCP:
EtherNet/IP:
Communication interface X21 with RJ45 connection
For serial RS485 communication via VA Bus or Modbus protocol.
BONFIGLIOLI Vectron provides an interface adaptor for the USB connection of a PC.
This enables parametrization and monitoring via the PC software VPlus.
Parameter copy
Parameter values can be stored on a memory card („Ressource Pack") and transferred from
one inverter to another inverter.
Reset to factory setting
Select P34 in menu item PARA.
Set P34 to 4444 and press ENT. This resets the parameter settings to the default values.
4443.
Key lock
Select P27 in menu item PArA and set a password. Then parameter values in menu item PArA
and the motorpoti function are password protected. Ten minutes after a correct password entry
the password inquiry is displayed again.

Further information

Detailed operating instructions can be downloaded from the BONFIGLIOLI website.
Device data
The following generic characteristics are valid for AGL202 and AGL402 devices:
Agile
Quick Start Guide
Parameter Display
P211
 
P212

P213

P240
 
P241
  
P259

P269
 
P310

CM-485
CM-232
CM-PDPV1
CM-CAN
CM-VABus/TCP
CM-VABus/TCP-2P
CM-EtherCAT
CM-ProfiNet
CM-Modbus/TCP
CM-Modbus/TCP-2P
CM-EtherNet/IP
CM-EtherNet/IP-2P
Press the arrow keys at the same time, to jump to the value
R.m.s output current of the frequency
inverter (motor current).
Output voltage of the frequency inverter.
Power of the motor at the current operation
point.
Motorspeed.
Output frequency of the inverter (actual fre-
quency of the motor).
The cause of error switch-off.
Warning because of a critical condition.
The last error.
®
46
CM
X21
05/2019