Display Measurement - X-Rite PANTONE i1 PRO 3 PLUS Manual De Uso

Display Measurement

3
24
2
1
To prepare your i1Pro 3 device for a display measurement you need to mount the i1Pro 3
device on the display holder. Make sure your device is calibrated and the status indicator
is pulsating white before you mount the device.
1. You can adjust the length of the counter weight of the display holder for the size of
your screen. The counter weight is equipped with hook-and-loop fasteners on both
ends which allow you to shorten and lengthen the display holder to the correct length.
2. Mount the i1Pro 3 measurement device on the display holder by inserting the
mounting connector on the display holder in the mounting interface at the rear of
the i1Pro 3 device. Make sure that the nose of the i1Pro 3 device seats firmly in the
display holder.
3. Fix the limiting aperture of the i1Pro 3 measurement device in the middle of your
screen.
4. Set the software for display measurement and start the measurement process in the
application. Status indicator lights switch off during measurement.
5. To remove the i1Pro 3 device from the display holder, gently pull the mounting
connector with the display holder out of the mounting interface at the rear of the i1Pro
3 device.
NOTE: Displays cannot be measured in M3 mode.
EN
25