1- Coupling The Cardan Shaft - Nogueira NEW PECUS G2 Serie Manual De Instrucciones

4. Preparation
TRACTOR
Recommendations:
ƒ The cut pieces of the bar, the tube and the
plastic protection of the cardan should have
the same length.
ƒ Using a lime, remove all the filings from the
tubes. Then, lubricate with a thin layer of grease.
ƒ Special attention should be given to the tube
and bar mounting on the square profile cardans.
The Terminals should be aligned as shown in the
figures below. Misaligned terminals generate
vibrations, wear and cardan breaks.
Right -
aligned
WRong -
misaligned

4.1.1- Coupling the cardan shaft

ƒ Before coupling, lubricate the two cardan shaft
terminals.
38
Instructions Manual
MACHINE