Sauder Hutch 109871 Instrucciones De Montaje página 10

6
Surface with
TWIST-LOCK
FASTENERS
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Position the SHELF (D) as shown.
NOTE: Be sure the surface with TWIST-LOCK
- Fasten the LOWER BACK (F) to the SHELF (D). Tighten six MINI TWIST-LOCK
edge of the LOWER BACK.
NOTE: Be sure the unfinished surface of the LOWER BACK is positioned as shown. Follow
the diagram.
109871
LOWER
BACK (F)
SHELF (D)
R
hole of the adjoining part while locking the FASTENER.
www.sauder.com/services
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
Unfinished
surface
R
FASTENER (Refer to the enlarged diagram.)
R FASTENERS on the SHELF is facing up.
R FASTENERS in the long