Publicidad
Idiomas disponibles
Idiomas disponibles
13
DOOR (H)
PIVOT
HINGE (CC)
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
1/2" FLAT HEAD SCREW (TT)
(4 used for the STRIKE PLATES)
9/16" LARGE HEAD SCREW (RR)
(4 used for the PIVOT HINGES)
- Position all four DOORS (H) as shown.
- Fasten one PIVOT HINGE (CC) to each DOOR (H) as shown. Use a 9/16" LARGE HEAD SCREW (RR) through
each PIVOT HINGE and into the pre- -drilled holes in the DOORS.
- Fasten a STRIKE PLATE (GG) to each DOOR (H) as shown. Use a 1/2" FLAT HEAD SCREW (TT) through each
STRIKE PLATE and into the pre- -drilled holes in the DOORS.
NOTE:
The surface of the STRIKE PLATES with "SAUDER" should be facing up. Be sure to position
the STRIKE PLATES as shown. Follow the enlarged diagrams.
IMPORTANT:
The HINGES and STRIKE PLATES must be fastened to the DOORS in the positions
shown. The edge to which the HINGES are now fastened will be the top edge of
the DOOR.
STRIKE
PLATE (GG)
PIVOT
HINGE (CC)
RIGHT
www.sauder.com/services
IMPORTANT:
ONLY FASTEN ONE HINGE TO
EACH DOOR IN THIS STEP.
PIVOT
HINGE (CC)
DOOR (H)
WRONG
PIVOT
HINGE (CC)
STRIKE
PLATE (GG)
109871
Publicidad
