Publicidad
Idiomas disponibles
Idiomas disponibles
9
CORD
CLIP (DD)
9/16" LARGE HEAD SCREW (RR)
(15 used in this step)
- Fasten the TOP MOLDING (J) to the ANGLE BRACKETS (II) on the TOP (C) as shown. Use a 9/16" LARGE
HEAD SCREW (RR) through each BRACKET and into the groove in the TOP MOLDING.
NOTE:
The TOP MOLDING is not as thick as the SHELF MOLDING (I).
NOTE:
Be sure to position the TOP MOLDING as shown. Be sure the holes in the TOP MOLDING are
positioned toward the SHELF (D) as shown. Do not overtighten the SCREWS. Follow the
diagram closely.
- Fasten the SHELF MOLDING (I) to the ANGLE BRACKETS (II) on the SHELF (D) as shown. Use a
9/16" LARGE HEAD SCREW (RR) through each BRACKET and into the groove in the SHELF MOLDING.
NOTE:
Be sure to position the SHELF MOLDING as shown. Be sure the holes in the SHELF
MOLDING are positioned toward the TOP (C) as shown. Do not overtighten the SCREWS.
Follow the diagram closely.
- Fasten two LIGHTS (Q) to the TOP (C) as shown. Use two 9/16" LARGE HEAD SCREWS (RR) through the
round holes in the LIGHT and into the pre- -drilled holes in the TOP.
NOTE:
Be sure to position the LIGHTS as shown. Follow the diagram.
- Now, push the CORD CLIPS (DD) into the indicated holes in the SHELF (D). The CORD CLIPS are used to hold
any light that you may purchase for the unit.
TOP
MOLDING (J)
SHELF
MOLDING (I)
TOP (C)
SHELF (D)
www.sauder.com/services
LIGHT (Q)
The holes in the
MOLDINGS
must be facing
each other.
109871
Publicidad
