Publicidad
Idiomas disponibles
Idiomas disponibles
14
Fasten a
BACKPLATE (XX)
and PULL (WW) here.
GG
DOOR (H)
PIVOT
HINGE (CC)
PLASTIC
WASHER (JJ)
Only the Hutch is shown in this step.
DOOR ATTACHMENT :
1st:
Insert a free PIVOT HINGE (CC) as shown, through a PLASTIC WASHER (JJ),
and into theSHELF MOLDING (I).
2nd:
Insert the PIVOT HINGE (CC), which is fastened to a DOOR (H), into the TOP MOLDING (J). You will
need to tilt your DOOR slightly.
3rd:
Now, tip the DOOR (H) in and fasten the free PIVOT HINGE to the DOOR. Use a 9/16" LARGE HEAD
SCREW (RR).
Repeat this step to fasten the three remaining DOORS (H).
-
NOTE:
Door adjustments can be made by slightly loosening the SCREWS in the PIVOT HINGES and
moving the DOOR as needed. Be sure to tighten the SCREWS after making adjustments.
- Now, fasten a BACKPLATE (XX) and PULL (WW) to the front surface of each DOOR. Use a 1" MACHINE
SCREW (OO) through the back side of each DOOR, through a BACKPLATE, and into a PULL.
NOTE:
Be sure the post on the back of each BACKPLATE inserts into the small hole in the DOORS.
The small hole will be above the large hole on the left DOORS and below the large hole on the
right DOORS.
109871
nd
2
rd
3
LEFT
END (B)
+
HH
SHELF
MOLDING (I)
st
1
www.sauder.com/services
1" MACHINE SCREW (OO)
(4 used for the PULLS)
TOP
MOLDING (J)
9/16" LARGE HEAD SCREW (RR)
(4 used for the PIVOT HINGES)
Publicidad
