Publicidad
Idiomas disponibles
Idiomas disponibles
11
Tighten these three
MINI TWIST-LOCK
R
FASTENERS in the
LOWER BACK (F).
RIGHT
END (A)
NAIL (UU)
(30 used in this step)
- Carefully turn your unit over onto its front edges.
- Fasten the LOWER BACK (F) to the RIGHT END (A) and LEFT END (B). Tighten six MINI TWIST-LOCK
FASTENERS in the short edges of the LOWER BACK.
- Lay the UPPER BACK (E) over your unit with the unfinished surface facing up.
NAILING ON THE UPPER BACK:
1st:
Be sure there is an equal amount of margin along all four edges of the UPPER BACK. If needed, push on opposite
ends of the unit to be sure your unit is "square."
2nd: Tap a NAIL (UU) into the row of holes along the top edge of the UPPER BACK (E).
3rd: Then, tap a NAIL into the row of holes along the bottom edge of the UPPER BACK.
- Continue fastening the UPPER BACK (E) to your unit using the NAILS (UU).
NOTE:
Be sure to tap NAILS into the holes across the middle of the UPPER BACK. Perforated cut- -out
lines have been provided in the UPPER BACK. Carefully cut out the hole needed.
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
UPPER
BACK (E)
LOWER
BACK (F)
www.sauder.com/services
STOP
STOP
Do NOT stand the unit
upright without the
BACKS fastened. The
unit may collapse.
Unfinished
surface
Tighten these three
MINI TWIST-LOCK
FASTENERS in the
LOWER BACK (F).
LEFT
END (B)
R
R
109871
Publicidad
