Sauder Hutch 109871 Instrucciones De Montaje página 6

2
- Slide a patented* END MOLDING (K) onto the notched edge of each END. Carefully slide both MOLDINGS until
the MOLDINGS are even with both edges of each END.
NOTE: The MOLDINGS should overhang the surface with holes on the LEFT END and RIGHT END. If
the MOLDING overhangs the wrong surface, remove it and slide it on again. Slide the
MOLDING off the notched edge in the same direction that it was slid on.
* U.S. Pat. No. 5,499,886
109871
END
MOLDING (K)
LEFT
END (B)
Slide the END
MOLDING (K) onto
the notched edge.
www.sauder.com/services
Slide the END
MOLDING (K) onto
the notched edge.
RIGHT
END (A)
END
MOLDING (K)