Sauder Hutch 109871 Instrucciones De Montaje página 30

10
METAL
WASHER (KK)
(6 used in this step)
7/8" FLAT HEAD SCREW (PP)
(6 used in this step)
- Fasten the BULLETIN BOARD (O) to the LOWER BACK (F) as shown. Turn each 7/8" FLAT HEAD
SCREW (PP) through a METAL WASHER (KK), through the BULLETIN BOARD, and into the pre- -drilled holes
in the LOWER BACK.
NOTE: Pay close attention to the enlarged diagram of the METAL WASHER. Be sure not to fasten the
BULLETIN BOARD over the Light cord.
109871
SHELF (D)
BULLETIN
BOARD (O)
LOWER
BACK (F)
www.sauder.com/services
RIGHT
END (A)