Publicidad
Idiomas disponibles
Idiomas disponibles
5
END
MOLDING (K)
LEFT
END (B)
1- -7/8" FLAT HEAD SCREW (LL)
(4 used in this step)
- Position the TOP (C) on edge as shown.
NOTE:
Be sure the FRONT MOLDING (L2) is facing up and the finished surface is facing as shown.
- Fasten the LEFT END (B) to the TOP (C) as shown. Use two 1- -7/8" FLAT HEAD SCREWS (LL) through the
TOP and into the pre- -drilled holes in the edge of the LEFT END.
NOTE:
Be sure the END MOLDING (K) on the LEFT END is facing up.
- Fasten the UPRIGHT (G) to the TOP (C) as shown. Use two 1- -7/8" FLAT HEAD SCREWS (LL) through the
TOP and into the pre- -drilled holes in the edge of the UPRIGHT.
NOTE:
Be sure the finished edge of the UPRIGHT is facing up.
FRONT
MOLDING (L2)
Finished
edge
UPRIGHT (G)
www.sauder.com/services
TOP (C)
Finished
surface
109871
Publicidad
