Jøtul F 470 Serie Instrucciones Para Instalación página 14

ENGLISH
4.4 Assembling the sides
Aluminium or glass sides
If you are installing aluminium sides and the flue pipe is rear-
mounted, you will need to saw holes for this using a hacksaw
blade.
Fig. 19
1. Loosen the screws on the top (Fig. 19 A).
2. Attach the lower bracket (Fig. 19 B) with the screw (Fig. 6 A)
that was removed from the bottom of the burn chamber
earlier on.
3. If you are installing aluminium sides, glue the gaskets (Fig. 19 C)
onto all the brackets.
4. Move the aluminium/glass side into position in the section.
NB! If there is a crack between the aluminium panels and
the brackets, an extra gasket (Fig. 19 C) should be glued to
the bracket at the place where the crack is.
5. Move the upper section into position and secure loosely
with screws.
6. Do the same on the opposite side.
7. Adjust the sides at the back edge.
8. Check there is a clearance between the weights and the
aluminium/glass sides. If necessary, adjust the panels
outwards.
9. Refit any parts that have been removed from the product.
10. Finally, tighten all the screws.
14
Cast iron sides
Fig. 20
1. If installing the flue pipe at the back, first drill a hole in the
removable cover plates (Fig. 20 A) before they are knocked out.
2. Loosen the screws on the top (Fig. 19 A).
3. Put the sides on and secure with screws on the top.
4. Lock the sides onto the underside with screws (Fig. 6 A) that
were removed from the bottom of the burn chamber earlier
on. The sides should fit into the slots along the back edge.
Tighten the screws while holding the sides in the correct
position so that they do not slip out of place.
5. Check there is a clearance between the weights and the
panels. If necessary, adjust the panels outwards.
6. Refit any parts that have been removed from the product.
Soapstone side panels, Jøtul F 476
The side panels come in two packages. A bracket is mounted onto
each soapstone side panel.
Fig. 21
1. Move the bracket (Fig. 21 A) to the opposite position on one
of the soapstone side panels. This should only be done if the
bracket is not located in the upper position. Do not tighten
the screws so much that the bracket cannot be moved up and
down with your hand. Make sure the bracket on the other
side panel is equally as loose.