Jøtul F 470 Serie Instrucciones Para Instalación página 15

Fig. 22
2. Loosen the screws (Fig. 22 A) on the top.
3. Raise a soapstone side panel at the end in which the bracket
is mounted and place it into the base. Push the bracket until
it is at the same height as the screw hole (Fig. 22 A) on the
burn chamber. Then push the upper section of the soapstone
side panel up to the burn chamber and attach the screw
(Fig. 22 A). Do not tighten the screw yet.
4. Then fit the other side panel in the same way.
5. Attach the side panels onto the underside with screws
(Fig. 6A) that were removed from the bottom of the burn
chamber earlier on. Do not tighten the screw yet.
Fig. 23
6. When both side panels have been mounted, push them right
up to one another along the back edge and fasten at the top
only with a mount (Fig. 23 A).
7. Move the top plate into place and align carefully.
8. Finally, tighten all the screws.
9. If necessary, place the cover for the smoke outlet and inlet
air in the back edge.
10. Refit any parts that have been removed from the product.
4.5 Fitting a flue pipe with a top outlet
NB! With a top outlet, the flue pipe is installed after the outer
sides have been installed.
The product is supplied from the factory with the smoke outlet
fitted for the top outlet.
NB: It is important to remove the white foam plastic in the top!
1. Place the product in the correct position.
2. Place the top plate and the grate on top of the product.
3. Place the gasket on the edge of the flue pipe as illustrated
in Fig. 18 B.
4. Move the flue pipe into position.
NB: It is important for the joints/flue pipes to be sealed
completely. Air leaks may prevent them from operating properly.
ENGLISH
15