Bosch Rexroth BT356 Manual De Instrucciones página 39

3 609 929 B68/2008-11 | BT356
CAUTION
Damage to the BT356 card
rack or tightening system if
plug-in connections are
connected or disconnected
while under voltage!
y First switch off the system at
the mains and allow for a
minimum discharging time of
10 seconds.
CAUTION
Risk of damage to persons
and property!
y First switch off the system at
the mains before working on
the terminals and allow for a
minimum discharging time of
10 seconds.
y Check that the terminals are
not under voltage.
CAUTION
Risk of damage to persons
and property!
y Once the device has been
switched off, it cannot be
switched back on again until at
least 30 seconds have
elapsed.
Bosch Rexroth AG
Proceed as follows to disassemble the
BT356 card rack:
1. First switch off the system at the mains
and allow for a minimum discharging time
of 10 seconds.
2. Check that the terminals are not under
voltage.
3. Loosen the main power lines from the
card rack.
4. Loosen the knurled bolts on the front for
all components and remove them.
5. Mount dummy panels, if necessary (see
Table 11 on page 37).
39/124