Switching On Communication - BMW Motorrad 76 01 7 723 987 Manual De Instrucciones

2
10
Check by pulling wind baffle 1
off the microphone until white
area 2 normally concealed by
z
the baffle is visible.
The white area must be toward
your mouth and the black area
away from your mouth. If the
microphone has twisted out of
alignment:
Align the swan-neck com-
plete with microphone in such
a way that the white part of
the microphone is toward your
mouth. Twist the swan-neck
on its axis, but do not twist the
microphone towards the swan-
neck or the swan-neck towards
the holder. If necessary, seek
the advice of a specialist work-
shop, preferably an authorised
BMW Motorrad dealer.
Switching on
communication system
Press button 2 and hold it
down until a high-pitched con-
firmation tone sounds and
green LED 6 starts flashing.
The communication system
initialises itself; the green LED
slow-flashes.
The communication system
then goes to standby mode;
the green LED flashes as the
rate of one flash per second.
If the communication system
does not switch on:
Charging batteries (
If the red LED lights up and re-
mains ON after the system is
switched on, a system error has
occurred:
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
29).