BMW Motorrad 76 01 7 723 987 Manual De Instrucciones página 72

the section entitled "Technical
4
data").
Use the charging cable sup-
30
plied to connect the charging
adapter to a socket, or use a
USB cable to connect it to a
computer's USB port.
Excessive charge currents
when a USB interface is
used for charging can result in
damage to the communication
system.
Connect the charging adapter
z
only to interfaces that you are
sure are USB 2.0 or higher.
Do not connect a "power USB"
interface.
Switch on the computer to
start charging via the USB port.
The yellow LED 5 indicates pro-
gress during charging.
LED continually lit: The battery
is being charged.
LED not lit: The charge is
complete. Conservation char-
ging is now active.
LED flashing: The ambient
temperature lies outside the
acceptable limits or the battery
is being tested.
If the LED is blinking:
Check the ambient tempera-
ture (see technical data) and
move to a different charging
location if necessary.
If the ambient temperature is
within acceptable limits and the
LED blinks for longer than five
minutes, the chargeable battery
is defective:
Replace the battery.
If the battery is charged:
Disconnect the plug, close the
protective cap and tuck the
charging adapter back into po-
sition under the neck pad.