BMW Motorrad 76 01 7 723 987 Manual De Instrucciones página 55

Connection from
telephone to helmet
Connection set-up
Each helmet with a communica-
tion system can be paired with a
telephone of its own, but a tele-
phone can be paired with only
one helmet.
The configuration settings and
range of functions supported
by the telephone determine
whether or not connection set-
up between the communication
system and the telephone can
take place automatically. Always
refer to the instructions for use
of the device in question for
details. Note that the Bluetooth
function must be active; the
communication system might
have to be authorised or
authenticated.
Bluetooth devices have
to be "introduced to each
other " (paired) before they can
set up a connection for the first
time.
An incoming call is indicated for
approximately five seconds by
an acoustic alert and can be re-
jected within this period. If it is
not rejected the incoming call is
automatically accepted. Helmet-
to-helmet communication and
music playback are interrupted
for the duration of the telephone
call. An acoustic alert sounds in
the second helmet to indicate
that communication has been in-
terrupted.
While the call is in progress the
conversation can be passed back
to the telephone so that the tele-
phone can be used directly to
conduct the conversation.
The call is ended as soon as the
other party hangs up, but can
also be terminated by means of
the controls on the helmet or
manually at any time.
Communication between the two
helmets is restored, or music
playback resumed, as applicable,
as soon as the telephone call is
over.
Operation
Switch on the telephone and
the communication system of
the corresponding helmet.
Check the telephone to make
sure that the connection has
been automatically established.
2
13
z