Power Cord Caution; Operating Other Pioneer Components - Pioneer VSX-D712-S Manual De Instrucciones

Connecting up
• To hear sound only from the pre-outs,
disconnect any speakers that are
connected directly to the receiver.
• If you're not using a subwoofer, change
the front speaker setting (see Speaker
setting on page 44) to large.
• VSX-D712 only – If you connect to a
surround back speaker, make sure the
Surround back speaker setting on page 45
is switched on and set to the proper
speaker size.

Power cord caution

Handle the power cord by the plug. Do not
pull out the plug by tugging the cord and
never touch the power cord when your hands
are wet as this could cause a short circuit or
an electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or
pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords
should be routed such that they are not likely
to be stepped on. A damaged power cord can
cause a fire or give you an electrical shock.
Check the power cord once in a while. When
you find it damaged, ask your nearest Pioneer
authorized service center or your dealer for a
replacement.
All manuals and user guides at all-guides.com
Operating other Pioneer
components
By connecting a control cord (optional), you
can point the remote controls of other Pioneer
components at the receiver's remote sensor.
The remote control signals are received by the
remote sensor of this unit, and sent to the
other devices via the CONTROL OUT terminal
of the receiver.
OUT IN
CONTROL
Receiver
Other Pioneer products
with CONTROL terminals
Remote
control
Connect to CONTROL
unit
terminal of other
compatible Pioneer products
04
CONTROL
IN
OUT
27
En