Resetting The Main Unit - Pioneer VSX-D712-S Manual De Instrucciones

Additional information
Problem
Can't operate the remote
control.
The display is dark or off.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.

Resetting the main unit

Use this procedure to reset all the receiver's settings to the factory default. Use the front panel
controls to do this.
1 Switch the receiver on.
2 While holding down the TONE button, press and hold the
for about three seconds.
3 When you see RESET? appear in the display, press the TONE button.
OK? shows in the display.
4 Press TONE once more to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default
settings.
All manuals and user guides at all-guides.com
Remedy
• Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press FL DIMMER on the remote control repeatedly to return to
the default.
STANDBY/ON button
11
69
En